stimpy

would a blockage in front to rear pipe i replaced cause front to over pressure and rear to be under on citroens ive had before, when changing spheres ive changed the one that spurts out lhm rather than the one that does'nt, both front ones do not spurt out when removed

when i purchased from non citroen shop he got my parts by giving him reg number so i assume standard ones but my 5yr old grand son can lift and lower quite easily, he keeps doing this pretending hes superman :) are comfort ones realy that soft?

hi rear suspension became very bouncy, the front was fine, however i replaced both spheres on the rear and replaced a front to rear pipe as had small leak, upon finish and starting up the rear suspension is so soft i can easily lift up back and push down fully very easily where as the front has now become stiff and bouncy (front spheres not changed as were fine before) ive raised and lowered suspension several times in case air is in the front to rear pipe i replaced but no joy,, going to bleed rear brakes 1st even though they work fine, any suggestions on cause before i buy new front spheres as i beleve they ok

during reset procedure is it normal for headlamps to come on?

ive had diagnostic check done and there is no power going to the ecu , does anyone know which wire or wires on the plug are the power sources ive cleaned all the plugs with cotact cleaner but no joy as yet

hi thanks for quick replies, key reseting sounds most likely but when i got the car last year i tried connecting 2 of them reader gizmos just to see if any probs but both devices say cannot connect to vehicle but has been very reliable till now, so maybe not poss to reset keys ive since noticed that after turning on and all check lights go out abd a bearly audible high pitch squeal comes from around the dash (very quiet)

hi. my c5 wont start , engine turns over but the yellow key light on dash lights up when trying to start. all was fine till i disconnected battery and unplugged fuse box and comp module so i could get access to replace brake pipe after reconnecting car spluttered a bit when pressing pedal ran for about 5 miles then cut out all dash lights go out as normal (sometimes airbag light might stay on but thats always done that) changed fusebox and lift pump in tank but no change Already tried reset procedures found on net

hello im replacing a pipe on power steering xantia 2l hdi (too corroded for mot) problem is the way the metal pipes fits to the rubber section, is this permenantly fixed as the ends are not hex to fit spanner on or do i have to replace the whole bit im hoping to just replace the metal pipe theres normal spanner fitting one end but un sure how to undo the pipe where it joins the flexible rubber part

hi the engine block on my 1.8 xantia lpg has cracked, its factory fitted lpg, i can get hold of replacement engine from another xantia that is not lpg, how difficulf if poss is changing engines and keeping lpg system ,does it mean changind the head or manifold ect, how straightforward is the swap if at all possible thanks