sifaan

Thanks Paul... the other suppliers also claim to meet the PSA spec (PSA S71 2710) but I don't know if that's a legitimate claim or not :(

Hi When buying LDS, is it recommended to stick to Total? I see there are several other brands offering LDS on ebay - e.g. Mannol, Kerex, Syntex - which are about 20% cheaper than Total. I don't mind to pay extra if the Total LDS is of better quality, but otherwise I don't like to pay extra just for the name. Thanks /Sifaan

Thanks Paul I will try to get a replacement part (from a breaker) as I'm passing thru London later this month (and if I don't use this opportunity, it can be tricky to find someone to bring it to Sri Lanka)

Hi all When I hook up my lexia clone, there are (among others) two faults as follows: In the Combine ECU; "Remote Fault. Permanent Fault. Oil Temperature incorrect value received" In the BSI; "Permanent fault. Oil level sensor" Also, the gauge on the dashboard that shows the oil temperature isn't working. What sensors might be faulty here? #18 might be the oil level sensor where is the oil temperature sensed? Is it #16 - the "oil pressure switch" ? Thanks

Small update on this - it seems it was a problem in the BSI and the electrician was able to open it up and fix it (I think some tracks had been damaged or something like that). Now the washers (both front and back) work as expected

In the early days the washer worked for the back but not the front; so the garage put a splitter on the pipe going to the back to feed the front (so, if I switch on the rear washer I got water from the front and the back, albeit at a reduced pressure). They were not able to get it to work in both directions and replacing the Comms (the horn was malfunctioning) didn't solve it. This wasn't an issue with the pump (pump worked both ways when powered directly) but might have been an issue with the wiring (e.g. if it was Signal 1 + Ground rather than Signal 1 + Signal 2) or with the BSI. More recently (for a few years!) it doesn't work in either direction and the electrician said it's a BSI issue as well :(

Hi I’m doing well although the car is as usual keeping me busy (busted starter motor, blocked radiator, etc) :/ The electrician says he tried a different comms (from a 406 so might not be the exact part) and it seems to be that some signals are not coming from the bsi. Is that possible? I imagine the blades stopping midscreen are more likely a bsi issue than a stalk issue? In case of replacing the bsi, I think either I have to pay a kidney to get a new coded unit or buy a used bsi, ecu and key as a set. In the latter, what features do I need to match (and what can be programmed?)? Eg is it enough that it’s a c5 1st gen? Does it need to be from a petrol car? EW10J4 engine? Automatic? Thanks

Hi all I had a strange problem with the wipers - on manual control, it worked on normal speed but not on high (and when on auto, when it decides to switch to high speed, the wipers just stop) An electrician checked the Comms unit (there's also a problem where there doesn't seem to be a signal going to the washer motor at all but that is at least partly to do with wiring as the comms unit was replaced a while back - before and after the replacement the washer motor only worked on the rear washers) and after that the situation is that it only works on high setting, but at normal speed Also, if I stop the wiper, rather than returning to "home", it just stalls where it's at What should I be looking to replace? (I'm in Sri Lanka but will be passing thru London on transit early next month, which gives me an opportunity to pick up some parts!) BTW The auto setting no longer works - windscreen had to be replaced and ended up with the screen without the boss for the mirror housing that could hold the rain/sun sensors :/ (plus I'd need to buy the sensors and glue them anyway, since the old ones were pried off) Thanks!

Hi Paul What to you use to get access to the part numbers? From my installation I have Diagbox (that's for the diagnostic tool?) Citroen Sedre backup (wiring diagrams) Citroen DocBackup (get an error saying the application is out of date) - is this the one I should use for part numbers? thanks

Hi again Finally got around to checking my old download ("Citroen Service Box (DocBackup + Sedre) (11.2013)") and I think this doesn't have the functionality that was provided by service.citroen.com - is that correct? i.e. the emanualonline offering is something different? Thanks

Just an update - had it taken out and took it to a guy specializing in alternators and he was able to fix it (cost ~30 pounds) - the rotor coil had burned out or something. And then refitted for 8 pounds :) the mechanic (more experience with Pug) said on the 406 etc if they repair the comm type alternator the battery light comes on on the dashboard and that's why they don't go for it. I anyway don't have a battery light on dash, but the battery shop confirmed the alternator is giving a good output @ESL57 - getting stuff from UK to Sri lanka takes time (unless there's someone known traveling who can hand carry it

thanks paul / coastline for the help; will talk to the mechanic and see about a repair option. (and things are generally OK, except the C5 always finds something to keep me occupied - most recent drama was a crack in the windscreen that required me to import a glass from UK. and then it turned out to not have the mount for the rain/light sensors, and had to get down a regular mirror since the electric one couldn't be mounted on it!)

Hi Since service.citroen.com is blocked from Sri Lanka (and at the moment I don't have access to the downloaded version) could someone help me with 1. part number for the alternator for car VF7DCRFNF76343402 2. in case of buying a used alternator, what other C5's (first generator otherwise, or maybe even 406) can I get parts from? my mechanic tells me there are two types of connectors - the socket/plug ("comm" model, that I have), or another type that has a screw/bolt - but are there any other differences I need to watch out for? Thanks! /Sifaan

Thanks, I'm downloading it off a torrent - it's less convenient than the online service (especially with the XP VM hassle) but that looks like the only option for me :( (and I'm guessing it's too much trouble for Citroen to shut these down)

I wouldn't mind creating a new account, but there isn't an option to create a new account when I access from here (haven't seen one for quite a while) - maybe the "crackdown" started much earlier...