Hartmut

eaabos did a good explanation on what is needed to get the window switch working again. The yahoo owners club as well as Citroen itself reports an overly complicated procedure. All you need is to open up the rear door cover that much that you can reach the actuator for the window to open. just pop out a few plugs and you can reach in there.http://www.ercoupe.info/citroen/IMG_1149.JPG Pull up or down on the rubber boot until the window pops open. With the window open you will need to remove only one cover. Slow and careful. So nothing breaks. A screwdriver is of help here. http://www.ercoupe.info/citroen/IMG_1146.JPG Check the switch between the two contacts under the foam. Pressing the switch should give a solid circuit between both wires. Solder wire to the lower solder point. http://www.ercoupe.info/citroen/IMG_1144.JPG Solder the other end of the wire to the cable found on the left hinge. It is the thinner red/yellow wire. http://www.ercoupe.info/citroen/IMG_1145.JPG Tape cable to the window. Done