Jump to content

immy

Members
  • Posts

    5
  • Joined

  • Last visited

immy's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Thanks for all advice and replies. When i get time i will take to Citroen dealer for diagnostic.
  2. I have tried battery reconnection procedure but no luck. The airbag light is fine, comes on when ignition switched on then goes out. Engine oil and water levels ok. Should i try bsi reset? I could get it checked on computer from a garage to check for fault codes etc but i don`t want to waste money because most dummies don`t know how to use their equipment properly. Anyone know of a reliable place where they know how to use the equipment, in Manchester. I am not far from city centre. ,
  3. Forgot to mention answer to your other questions. Yes the service light is still showing. There is no warning about brake pads and they all have plenty of life in them. I tried what someone mentioned in this forum. I did a service interval reset, holding trip button then switching ignition on for 10 seconds. Before, the service light stayed on from when i switched car on but after service interval reset when i start car the service light goes off as normal with all other lights but comes on again after about 2 or 3 seconds?
  4. Thanks for the replies Paul. Much appreciated. I will try what you have said. Just to confirm about airbag fault, there is no airbag light on, only the service light is on and a message appears in console display `airbag fault`. I will try connectors under seat but only problem is with it being Exclusive model the seats are electric and there is also a CD changer under driver seat so there are wires galore.
  5. Hi all. I bought a Citroen C5 2.0 HDI Exclusive (2003) a couple of weeks ago. It was fine until a week later when i got it serviced and had timing belt and waterpump done. When i got it back the service light was on and message showing was `airbag fault` and the other thing i noticed was a problem with central locking. When i bought it and sat inside and pressed lock/unlock button on dash you could hear the clonking noise and doors lock/unlock etc. But after i got it back, when i press lock/unlock button there is no noise that doors have locked but the red light shows on button when doors are locked but they can be opened from outside?? Whereas before they could not be opened from outside. The key fob works fine, when i lock i can hear noise and all doors lock and unlock properly. The only other thing mechanic mentioned was he had to change a fuse because 1 of the rear lights was out. Any clues? Regards
×
×
  • Create New...