ric_18

Thanks for reply paul it seem like were the only 2 on this forum lol. My bearings, best way to describe is an hour glass on its side 2 separate halves but the ones online are single even shaped?? Seems old cause im not convined these will fit

Hello My rear wheel bearings (inner and outer) seem to be open style tapered roller bearings and all the ones online are sealed ? Have they upgraded or am i missing something here? Car=1.4 petrol 05 c2 Thanks any advice appreciated

Hi all can anyone help. Does the petrol 1.4 c2 have an egr valve if so the location would be good. The reason im asking is because my c2 runs rough on idle "lumpy" ive cleaned the throttle body the best i can but thought egr could also do this?

Well it was sent off to a head specialist so would of hopped they would have checked for minimum clearance. Managed to get a rough idea from google as to what this connector does. The connector has wrote on it FACON 2022 MADE IN FRANCE from google it is a capacitor which reduces or eliminates interference but if not in place can draw power ftom spark plugs etc. Had any experience with this or were i could get one?

Ad on* Frustrated as it was fine before "cam belt slipped". This small black block like connector sits on the head its self on a threaded stud plus it has broke off completely now as i tried to open it up to find out if it actually does anything or if i could cut the block off and wire direct with eye terminal

Thanks for your reply. Car has just had head recon plus cam belt all under warranty from dealer. it has been lumpy idle since. I have pics but dont know how to put them on.???? it idles at 750ish but dips lower then up again and causing a chugging effect, yet when reving and driving it runs fine

Hi all C2 1.4 petrol 05 Idle is lumpy but fine when driving, thought i would check connectors etc and found one which is broken and i have no idea what it is. looking down at engine in front of injectors rh side next to the head (top right corner near enough) theres a stud sticking up with an eye terminal attached first then on top another eye woth a black connector attached to it????? It has broken of leaving to prongs sticking out i wonder if i can solder the wire direct to it or is the block important.