Johno

Hi guys just let u know I ain't had much luck with the weather, pissing down again, but will Defo come back once I have had a look, cheers guys

Thank you guys, the van goes 40mph ish up hills (any hill really), but struggles soon as hits 3000 revs to pick up speed, I will go through as much of these points on sat rookie2 as I can, really appreciate the help as I am no mechanic. And thank you for the boost pressure moderator and the help. Feel like am getting somewhere with it now and this is the last thing to sort out. Cheers

It was a £40 sensor, did not want to spend £100 on Oem for the amount I paid for the van. I plugged the snapon reader back in and cleared code and it has not returned. I will take the egr valve off and give it a clean next sat. What boost pressure should it have? And I will drive it to see what the reader says what boost power it is. Am not sure if actuator rod is moving or not, I will check that too and see if turbo gets air. What speeds do u think van should do up hills?

Thanks for help to guys, appreciate it.

Replaced maf sensor, very little smoke no, but no real performance change, van still very slow up hills,what do other peoples van revs climb to when going up hills?

Plugged mates mates snap on scanner in and says has errors p0101 air mass sensor circuit and p0110 intake air temperature sensor

Hi guys managed to look a van today, sorted brakes out, the rear drum brakes just needed adjusting on both sides, so easy job thank god. Noticed when test driving it today for brakes that it throws out a bit of black smoke when going up hills when it gets to around 3000 revs mark when engine needs to do a bit of hard work?? Ideas, turbo egr valve?? Cheers guys appreciate help.

Cheers rookie2, seemed strange it drove fine on flat and rubbish on hills, could not understand it at all, the brake lines were leaking at rear so changed piping and bleed then up,brakes go hard when engine is off, then pedal sinks down before getting any pressure when running so I thought would be master cylinder seals buggered, is there a way to check if vacuum pump is buggered?

Hi, my relay is a 04 2.0 hdi turbo, when driving on flat ground it goes well in all gears, going up hills in 2nd revs go past 3000, but in 3rd gear it it only just goes to 3000 revs and van will not go over 40mph, is this normal? Also brake pedal is non existent then at top but kicks in half way to the floor, think master cylinder gone? Thanks for your help!