Jump to content

Recommended Posts

Posted

ok folks,

 

went to try my 04 plate with the roof down today and came across a minor (hopefully) problem..

 

I turned on the ignition and slid down all the windows.

next was operating the roof switch to the desired position and then pressing the button again to slide the roof down onto the screen

I got the roof open fine and slid it back over the rear window.

next procedure is to press the rear screen opening button and lift the screen/roof combo.. no response.. not even a click.

tried pressing it from inside but again no joy and no click noise..

 

The screen button works fine when operating the button while the roofs up and closed or even partially open but not in the full back position..

 

Not having a wiring diagram or parts layout I have no idea where to go about tracing the fault..

 

Anyone have any insight into this?

Posted

Hi could be the wires from the screen close roof look at the cables on both sides of the screen these can break or it could be the micro switches test that there is a lectric supply coming through, other things are roof not closing this can be solved by using a screw driver in the hole in the back screen panel, push and twist this wont work if the screen is skew wift if so you need to remove panel to get at the motor remove this and the drive pinon square roof up to shut, USE only silicon grease on the roof sliders use a smll paint brush on the chanels hope this is of some help Bry

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...