Changing The Bulb In The Middle Panel

[agoes_bp]

Hi again,

Would you please give me the steps to do to change the bulb for the interior fan and temperature backlight panel, the one between driver and passenger seats.

Thanks before.

Best regards,
Agoes

[PZX]

It is not the easiest of tasks, most manuals recommed removing most parts of the dasboard, but you can do it with a small screwdriver with Blue Tac attached ..

Make sure you get the right ype of bulb, Citroen used two slightly different types.

1 - write down you radio code
2 - remove the radio
3 - move the wires so you can access the bulbs.
4 - remove faulty bulb - you may have to twist them half a turn before pulling them, depending on the type
5 - attach your new bulb at the connector end to a small screwdriver and position into its hole.
6 - twist the screwdriver to break the bond with the blu tac.
7 - tighten up bulb and check

Note you can also get impeded access from the passenger floor well if you need to get another hand or implement in there.

[PZX]

It is not the easiest of tasks, most manuals recommed removing most parts of the dasboard, but you can do it with a small screwdriver with Blue Tac attached ..

Make sure you get the right ype of bulb, Citroen used two slightly different types.

1 - write down you radio code
2 - remove the radio
3 - move the wires so you can access the bulbs.
4 - remove faulty bulb - you may have to twist them half a turn before pulling them, depending on the type
5 - attach your new bulb at the connector end to a small screwdriver and position into its hole.
6 - twist the screwdriver to break the bond with the blu tac.
7 - tighten up bulb and check

Note you can also get impeded access from the passenger floor well if you need to get another hand or implement in there.