Synergie Exhaust

[Guest fredcatt]

Hi everyone. I need to fit a complete exhaust system to my Synergie 2.0 HDi. Has anyone done this job ? I was wondering how easy it is to access the connection on the manifold pipe behind the engine. I know it is tackled from underneath but could it be done with the vehicle on axle stands or would it need to be upon a ramp like garages have? All answers appreciated. Just been reading that sad post from PamC8 It`s got me worried now as my cambelt is recomended renewed at 100,000 miles, it`s just clocked up 94,500.

[techbod]

probably need it higher than axle stands but still need them for safety reasons I use a large trolley jack but a garage lift would be easier, timing belt should be changed if you have owned it from new or have all the service documents as it might have been done

[Guest fredcatt]

probably need it higher than axle stands but still need them for safety reasons I use a large trolley jack but a garage lift would be easier, timing belt should be changed if you have owned it from new or have all the service documents as it might have been done

 

 

Thanks for that

 

Fred

[techbod]

just though id add to that ( have new bolts/clamps ready and heat gun to remove the broken studs if your unlucky ) it always happens to me ;)