Stevie a Posted March 29, 2016 Posted March 29, 2016 Hi, I have a c3 exclusive 1.4 hdi 16v on a 52 plate, I recently had to change the starter motor as it was faulty but after fitting the new one & putting the car back together it doesn't want to rev past 2000rpm, & it has no power, I can put the accelerator to the floor but it just doesn't want to go, there are no warning lights or anything up on the dash, iv checked all the hoses & connectors & all seems to be as it should, the only thing I think it may be is the mass air flow sensor that is in the pipe going from air box to turbo as this was taken on & off a fair bit to get access, can anyone tell me if I'm on the right track? I unplugged it & the car stayed the same so I'm assuming it is the cause? Any help would be appreciated, & will the maf from a c3 1.6 16v be a suitable replacement as I'm having trouble finding a reasonably priced one for the 1.4 engine, thanks. Quote
paul.h Posted March 29, 2016 Posted March 29, 2016 Welcome to the forum. It sounds as if the car is in limp mode. With the MAF unplugged does the engine management light (eml) on the dash light up ? When you first switch on the ignition the eml should come on until the engine has run for a few seconds, if it is not doing this then maybe the bulb has failed. It could well be the MAF, you should check its wiring and electrical connector in case they are the problem rather than the MAF itself. Ideally a code reader would be used to see what is the fault but OBD compliance on diesels was not required until 2004 so a low cost one may not work on your car. Have a look at this topic since it is possible the wiring could be the problem http://www.citroen-owners-club.co.uk/citroen/topic/22333-air-flow-meter-wanted/ The MAF Citroen part no. may be 1920LC (check using your VIN) and other engines have a different part number. An ebay search shows this part is also on some Fords and if you need a new one then copies are around £60, but copies do not always work as well as originals. Quote
Stevie a Posted March 29, 2016 Author Posted March 29, 2016 Thanks for your reply, the engine management light comes on when the car is started so the bulbs are ok, I did buy a code reader but unfortunately it dose not work on my model as it is pre 2004, I will have a good look at the wiring tomorrow to make sure nothing is damaged, but it was fine before I changed the starter motor, the breakers near to me has a maf sensor from a c3 Picasso but it is a 1.6 hdi, would this be the same part as on the 1.4? It looks identical, but not sure if it is the same part, thanks again for your help I'll post my findings if I can sort it!? Quote
paul.h Posted March 29, 2016 Posted March 29, 2016 The 1.6 hdi MAF has a different part no. possibly 1920GV so it will not work on your car. Quote
Landmark Posted April 4, 2016 Posted April 4, 2016 Double check you haven't dislodged a wire/connection when you did your starter motor work.Griff Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.